If everythings fine, you will get the ESP32 board in the results section, as shown in the below figure: We need to double-click on this module to add it in our project. If there are no issues by the end of the flash process, the module will be reset and the “hello_world” application will be running. Open the components Library of Proteus and search for 'ESP32'. Wrote 136672 bytes (67544 compressed) at 0x00010000 in 1.9 seconds (effective 567.5 kbit/s). Platform Espressif 32: ESP32 is a series of low-cost, low-power system on a chip microcontrollers with integrated Wi-Fi and Bluetooth. Wrote 3072 bytes (82 compressed) at 0x00008000 in 0.0 seconds (effective 5789.3 kbit/s). Platform Espressif 32: ESP32 is a series of low-cost, low-power system on a chip microcontrollers with integrated Wi-Fi and Bluetooth. Wrote 22992 bytes (13019 compressed) at 0x00001000 in 0.3 seconds (effective 558.9 kbit/s). We haven’t found any part for the ESP32 devkit DOIT board when we built the course. Pico has been updated authoritatively at DFRobot Fritzing-library This is. Running esptool.py in directory /esp/hello_worldĮxecuting 'python /esp-idf/components/esptool_py/esptool/esptool.py -b 460800 write_flash -b 460800 write_flash -flash_mode dio -flash_size detect -flash_freq 40m 0x1000 bootloader/bootloader.bin 0x8000 partition_table/partition-table.bin 0x10000 hello-world.bin esp32 devkit v1 with 30 GPIOs Then in Fritzing select Mine My Parts you can.